1967. Rolex GMT Master Ref 1675 : yet another water damaged watch :-(

Arrived at our workshop at 4pm today, still full of water. Last serviced in 1998.

Obviously with no time to spare, all other jobs were pushed aside.

Once the movement was out of the case, the full extent of the water related damage was revealed: luminous material was partially diluted and spread all over the matte dial. And exposed to normal room temperature, it quickly dried, attaching itself to the dial surface.

The only way to clean the debris was to dampen the dial once again and then carefully remove excess luminous material, while trying to preserve the hour markers, writing and minute track intact.

The entire operation took about 30 minutes and the dial was then washed once again and left to dry at room temperature.

Beyeler, Singer, Stern, Lemrich and Metelem are just some of the Swiss dial makers who produced dials for various Rolex models.

This particular dial is a nice example of a fully signed Beyeler tritium dial. The GMT hand is a later replacement, but the watch features its original riveted bracelet.

The watch was bought in early 1970 for $400 and still belongs to it's original owner.

Overall result? We'll - you be the judge.

Another vintage 1675 dial preserved for the future :)

A repair job that could have been avoided

An ‘unbreakable mechanical watch’ has yet to be invented.

Unfortunately, bad things happen to good watches.

Accidentally dropping a watch on a hard surface (tiled floor for example) is bad but in some cases even more damage is done after the watch has hit the floor.

For some reason, the watch owner, recovering from a state of shock, will pull the winding crown and try to turn the hands. By the time he realizes that the hands are ‘stuck’, it will be too late – the dial (and hands) would have already been scratched by floating debris of the watch crystal.

While crystal replacement is a relatively straight-forward and not terribly expensive job, a dial and hand replacement is, on the opposite, always a complex and pricey repair. A job that in most cases, could have been avoided.

So, if you are unlucky enough to have dropped your watch, do not make it worse. Here are a few tips to avoid further disaster:

• shattered crystal is not the end of the world – it is reparable, so do not panic.

• unscrew the winding crown and pull it straight out to stop the watch.

• DO NOT SET TIME or DATE.

• if the glass is only chipped or cracked, but not shattered (and the watch appears to be keeping time), DO NOT WEAR IT.
  
  Small crystal particles could still float inside the watch mechanism and will definitely cause further damage. Take it to an authorised Service Centre or an independent watch expert.
  

• if you accidentally dropped your watch, but cannot see any sign of external damage: I would strongly recommend to observe its timekeeping for the next 24 hours. Make sure to carefully examine the watch case, crystal, bezel, pushers and winding crown.
  
  If you notice anything unusual or find that 'something does not feel right’, do the right thing: take it to a watchmaker for an expert assessment.